Double Car Turntable: Turn Two Vehicles at Once and Always Exit Forward

Nov 05,2026

Look down at the photo below: two cars, one circular platform, brick pavers running straight across it, walls and planting close on both sides. There is no space here for a three-point turn, and reversing out into the lane would mean backing blind into traffic. Yet both drivers can leave facing forward, every time, without either car being moved out of the way first.

That is the whole point of a double car turntable. Where a single-car unit solves one driver's problem, a two-car platform solves the whole household's — or the whole site's — problem in a single rotation.

Two cars parked side by side on a brick-paved double car turntable in a narrow residential driveway
Two vehicles, one rotating platform — both leave the property facing forward.

What Is a Double Car Turntable?

A double car turntable is a large motorised circular deck, set flush into a driveway or garage floor, wide enough for two vehicles side by side. Both cars drive on, the deck rotates to the required angle (commonly 180°), and both drive off facing the exit. No reversing, no shuffling cars around, no multi-point turns in a space that was never designed for them.

In most two-car projects the platform starts at around 6 m in diameter, but the diameter and load rating are engineered around the actual vehicles — length, width, wheelbase and combined weight — plus the clearance available around the edge. That surrounding clearance matters: the cars need room to sweep past walls, posts and planting during rotation, not merely room to park.

Why One Large Platform Beats Two Small Ones

  • Nobody waits. With two separate turntables, one car often blocks the other. On a shared platform, both vehicles are repositioned in the same cycle.
  • Safer access. Forward entry and forward exit remove the daily reversing manoeuvre — the highest-risk part of any steep, narrow or blind driveway.
  • Less wasted space. A turning circle for two cars is far smaller than the manoeuvring space two cars would otherwise need independently.
  • Cleaner architecture. One circular joint in the paving reads as an intentional design feature; two competing circles rarely do.
  • Better use of a premium plot. On high-value, space-constrained sites, access that simply works is part of the property's value, not just a convenience.

How It Works, Step by Step

  1. Drive on. Both vehicles park on the deck, centred on the marked positions.
  2. Choose the direction. Rotation is available clockwise or anti-clockwise, from a wall-mounted panel or a remote operated from inside the car.
  3. Rotate. The deck turns slowly and smoothly under load. We typically specify our pin-gear drive — a toothed ring engaged by a pinion — which gives positive, controlled engagement even with an off-centre load, with less of the slip and wear associated with friction-wheel drives.
  4. Drive off forward. Hold-to-run (deadman) controls and limit stops can be specified where the site requires them, keeping the motion predictable.

Because the platform sits flush with the finished surface, a properly integrated installation is almost invisible when it is not turning.

Making It Disappear Into the Driveway

The deck can be supplied as a chequer-plate steel surface or as an infill plate designed to receive concrete, tiles, stone or brick pavers. The photo above is a good example of the second approach: the paver pattern continues across the rotating deck, so the turntable reads as part of the landscaping rather than as a piece of equipment. Matching the finish is usually the detail that decides whether an installation looks built-in or bolted-on.

Where It Makes the Biggest Difference

  • Narrow or shared residential driveways with no room to turn
  • Steep driveway entries and below-grade garages
  • Properties on busy roads or at blind corners where reversing is genuinely dangerous
  • Multi-car households, twin garages and small villa or apartment developments
  • Showrooms and dealerships that need to present or reposition two vehicles together

For a closer look at the single-vehicle version and its sizing logic, see our driveway car turntables.

Before You Order: Five Things to Check

  1. Clearance around the circle, not just the diameter — check walls, gates, columns, kerbs and planting at full rotation.
  2. Foundation and drainage — a shallow pit or surface-mounted frame, with water kept out of the drive area.
  3. Power and control locations — where the panel goes, and whether remote operation from the vehicle is required.
  4. Vehicle data — the largest car's length, width, wheelbase, overhang and weight, plus the combined load.
  5. Local approvals — some councils or building managers require sign-off for motorised equipment in a driveway.

Send those five items with a photo or a simple site sketch and an engineer can size the platform properly on the first pass.

Frequently Asked Questions

Can the two cars rotate independently?

On a single circular deck, both vehicles rotate together — that is what keeps the structure simple and the cost sensible. If a project genuinely needs independent rotation, that means a split-deck or two-platform layout, which we engineer separately.

Will it fit an existing driveway?

Usually yes. Most installations are shallow-pit or surface-mounted and can be retrofitted, provided there is drainage and a power supply. The surrounding paving is reinstated to match.

What about rain or an off-centre load?

The drive ring and support wheels are designed for outdoor use and uneven loading, including the case where only one car is on the deck. Drainage and sealed electrical components are part of the specification.

How is it controlled?

Wall-mounted panel, in-vehicle remote, or both; clockwise and anti-clockwise. Control logic is specified to suit the site.

Tell Us About Your Space

A double car turntable is not an off-the-shelf purchase — the diameter, finish and foundation are set by your site. The fastest way to find out whether one fits is to send us a photo and a few dimensions.

Not Sure a Double Car Turntable Fits Your Driveway?

Send us a photo and the dimensions, including the clearance on both sides. Our engineers will recommend the right diameter, finish and installation approach.

Check My Space Fit → Chat on WhatsApp

Ask Us About a Turntable

Tell us about your space and vehicle. Our engineers will get back to you within 24 hours.